CombiCam

Installing the CombiCam

• Insert lock body through the front of the 3/4" drilled hole
• (Wood Only) Place prong washer over lock body, prongs facing wood.
• Thread Cylinder Nut and tighten.
• Attach stop cam (square piece with one round side and square hole)
• Attach straight cam (long piece with square hole)
• Secure with screw & lock washer (one piece)

Instructions for Changing combination

• The default combination is 0-0-0
• Set combination to the open number
• Locate a small hole on the outside of the lock
• Press a paper clip into this hole to press the reset button
• Rotate the combination to the new number
• Release the reset button

Your Lock is now set!

How to permanently set a combination

• Take off the screw to the cam and remove the "cam" and "stop cam"
• Rotate cylinder 180 degrees & put "stop cam" and "cam" back on