PBMinutes

Camera Z Mount knobs hit each other

Camera Z Mount is too long

Need LED Ring

Need a mechanism to lock booth down

Need lift handles

[done]Need wheels

[done]Need pull handle

Need to design in hatch back

[done]Need to buy and laminate wood

Need to buy backdrop

Make Cap touch Sensor

• step 1) print out a stencil
• step 2) tape a copper sheet onto the back of the stencil
• step 3) cut out stencil
• step 4) apply PSA to top of the copper tape
• step 5) peel off PSA protector and stick to polyethalyne
• step 6) scratch off paper using knife or water (only enough to solder to)
• step 7) solder a 30awg or smaller wire to that electrode
• step 8) add a female header socket to the end of the 30 gauge wire
• step 9) add more PSA
• step 10) add 1/4" polyethalyne to back of sensor to protect it
• step 11) add a LED, EL, matrix or other type of back light to illuminate this assembly