PBMinutes

Camera Z Mount knobs hit each other (30min DYE)

• Turn the second hole into a slot so it looks intentionally adjustable
• Re-drill holes wider? (makes it look unintentional)

Camera Z Mount is too long (1hour DYE)

• De-rivet right angle
• Cut aluminum section
• re drill, re-rivet piece in

Mount in Camera support rails (30min FRI)

• drill slide rail holes
• Rivet into box

Make Cap touch Sensor (1 hour DYE)

• step 1) print out a stencil
• step 2) tape a copper sheet onto the back of the stencil
• step 3) cut out stencil
• step 4) apply PSA to top of the copper tape
• step 5) peel off PSA protector and stick to polyethalyne
• step 6) scratch off paper using knife or water (only enough to solder to)
• step 7) solder a 30awg or smaller wire to that electrode
• step 8) add a female header socket to the end of the 30 gauge wire
• step 9) add more PSA
• step 10) add 1/4" polyethalyne to back of sensor to protect it
• step 11) add a LED, EL, matrix or other type of back light to illuminate this assembly

Make new front panel (1 hour DYE)

• cut wood to size
• cut plastic to size
• apply adhesive to surface and install window

Install Monitor (2 hour FRI)

• Cut out hole
• Design and install retention system
• must be removable

Need LED Ring (4 hours FRI)

• make template
• stack 3 1/8" sheets together
• cut out template
• drill 40 holes
• Wire in 40 LEDs common cathode.
• Wire 5 drive circuits

Need to design door (2 hours DYE)

• Need to cut door out
• install piano hinge
• install rigid extrusions
• install backing
• install combi-lock

Need Foot Stands (30 mins DYE)

• Lathe
• 4 Delrin holes

Need a curtain and backdrop (FRI)

Need to add Threaded Rivets for Future Expansion

Need to add top optical exit window for vertical flash system

Need a mechanism to lock booth down

Need lift handles

Need to buy backdrop

[done]Need wheels

[done]Need pull handle

[done]Need to buy and laminate wood