PBMinutes

Camera Z Mount knobs hit each other

• Turn the second hole into a slot so it looks intentionally adjustable
• Re-drill holes wider? (makes it look unintentional)

Camera Z Mount is too long

• De-rivet right angle
• Cut aluminum section
• re drill, re-rivet piece in

Mount in Camera support rails

• drill slide rail holes
• Rivet into box

Make Cap touch Sensor

• step 1) print out a stencil
• step 2) tape a copper sheet onto the back of the stencil
• step 3) cut out stencil
• step 4) apply PSA to top of the copper tape
• step 5) peel off PSA protector and stick to polyethalyne
• step 6) scratch off paper using knife or water (only enough to solder to)
• step 7) solder a 30awg or smaller wire to that electrode
• step 8) add a female header socket to the end of the 30 gauge wire
• step 9) add more PSA
• step 10) add 1/4" polyethalyne to back of sensor to protect it
• step 11) add a LED, EL, matrix or other type of back light to illuminate this assembly

Make new front panel

Install Monitor

• Cut out hole
• Rivet in right angle holder

Need LED Ring (4 hours)

• make template
• stack 3 1/8" sheets together
• cut out template
• drill 40 holes
• Wire in 40 LEDs common cathode.
• Wire 5 drive circuits

Need to design door

• Need to cut door out
• install piano hinge
• install rigid extrusions
• install backing
• install combi-lock

Need Foot Stands

• Lathe
• 4 Delrin holes

Need a mechanism to lock booth down

Need lift handles

Need to buy backdrop

[done]Need wheels

[done]Need pull handle

[done]Need to buy and laminate wood