Difference between revisions of "Fireball V90"
From CunningWiki
| Line 9: | Line 9: | ||
'''Machine Specifications''' | '''Machine Specifications''' | ||
| − | + | ''FireBall V90 CNC Router (FireBall V90)'' $1,334.80 | |
*Motor/Driver Kit => 3-Axis ProboStep Motor/Driver Kit (Best) | *Motor/Driver Kit => 3-Axis ProboStep Motor/Driver Kit (Best) | ||
| Line 25: | Line 25: | ||
*Mount For PC7310 or D26670 Trim Router (PCMount) $49.95 | *Mount For PC7310 or D26670 Trim Router (PCMount) $49.95 | ||
| − | + | ''Machine Travel:'' | |
*X-Axis ~18" | *X-Axis ~18" | ||
| Line 33: | Line 33: | ||
*Z-Axis ~3" | *Z-Axis ~3" | ||
| − | + | ''Leadscrew Pitch:'' | |
*X-Axis 5 Turns Per Inch (0.2in per rev/5.08mm per rev) | *X-Axis 5 Turns Per Inch (0.2in per rev/5.08mm per rev) | ||
| Line 41: | Line 41: | ||
*Z-Axis 12 Turns Per Inch (0.08334in per rev/2.1167mm per rev) | *Z-Axis 12 Turns Per Inch (0.08334in per rev/2.1167mm per rev) | ||
| − | + | ''Resolution:'' (X & Y Axis) | |
*Full Step 0.001" | *Full Step 0.001" | ||
Revision as of 13:55, 16 April 2011
CAD Software - This is the computer aided drafting tool you use to draw your models.
- Sketchup
CAM Software - This is the software that creates the tool paths for the milling machine to cut
- MeshCam
CNC Control Software
- Mach3
Machine Specifications
FireBall V90 CNC Router (FireBall V90) $1,334.80
- Motor/Driver Kit => 3-Axis ProboStep Motor/Driver Kit (Best)
- Drive Nuts => Anti-backlash
- Breakout Board => PBX-RF
- Ready-to-run => Large Enclosure
- Kit Power Supply Upgrade => 40VDC Linear RTR
- Spoil Board => MDF
- Mount For PC7310 or D26670 Trim Router (PCMount) $49.95
Machine Travel:
- X-Axis ~18"
- Y-Axis ~12"
- Z-Axis ~3"
Leadscrew Pitch:
- X-Axis 5 Turns Per Inch (0.2in per rev/5.08mm per rev)
- Y-Axis 5 Turns Per Inch (0.2in per rev/5.08mm per rev)
- Z-Axis 12 Turns Per Inch (0.08334in per rev/2.1167mm per rev)
Resolution: (X & Y Axis)
- Full Step 0.001"
- Half Step 0.0005"
- Quarter Step 0.00025"
- Eighth Step 0.000125"
- Sixteenth Step 0.0000625"
