View source for Radio Controlled Stepper Tool Checklist

These are the tools you will need to put together a [[Radio Controlled Stepper]] kit.

== Required Tools ==
<tab class=wikitable sep=comma>
[[File:Tools_soldering_iron.JPG|225px|center|]], '''Soldering Iron'''. Any standard soldering iron with a pencil tip will be fine. Avoid using the cheap $10 soldering irons; they are a lot harder to solder with than the better irons.
[[File:Tools_solder.JPG|225px|center|]], '''Solder'''. Use rosin core solder. A thin diameter solder will work much better for this project than thick diameter solder.
[[File:Tools_flush_cutters.JPG|225px|center|]], '''Flush Cutters'''. Used to snip of long leads once you solder a component in place.
</tab>


== Optional Tools ==
<tab class=wikitable sep=comma>
[[File:Tools_panavise.JPG|225px|center|]], '''A third hand'''. Something to hold the PCB for you while you solder on it. This is very helpful but you can get by without it.
[[File:Tools_desoldering_braid.JPG|225px|center|]], '''Desoldering braid'''. If you make a mistake soldering you can use this to remove the solder and try again.
</tab>